News
How to Install Raymond Mill Correctly?2017-10-11
As we all know, Raymond mill is one of the common mining equipment, and the Raymond mill can be used in lots of industry areas. However, do you know, how to install Raymond mill correctly? Clirik engineer would tell you a little tip.
First, put the base of arranger into pit and fill the pit. Pay attention to control a certain height, and then use level to adjust the upper plant "A", at the same time install drive device in the "A" surface and bolt it.
And then. Before installation, rubber shockproof pad should be filled on the base bottom plane contact with cement foundation and anchor bolt connection. and then use frame level to revise base "B" plant.The calibration points are the four cross. At the same time adjust the two half coupling "C", "D", whose axis degree should be less than 0.20 mm. the non parallelism degree of “E”, “F” shouldn't be greater than 0.1 mm, the gap between “E” and “F” should be kept within 5-8 mm.
Finally, the location of the pipe work shall be installed according to the general layout and height, shall not be any change. Each pipe joint shall be sealed and tighten, make sure that have no leakage phenomenon. Electrical equipment should be accurate and reliable, all parts should be carried out commissioning after the Raymond mill is installed.
Do you want to know more knowledge about Raymond mill installation and operation? Welcome to leave your question on our website, our technical engineer would contact you as soon as possible. Thanks for your reading.